Two Chassis, One Envelope: What Splitting a Mission System Inside the SAVE Envelope Actually Costs
A fixed vehicle envelope and a requirement to physically separate security enclaves can move a design decision from the system […]
A fixed vehicle envelope and a requirement to physically separate security enclaves can move a design decision from the system […]
A November 16, 2026 announcement from Pixus Technologies, reported by EE Journal{:target="_blank" rel="noopener"}, describes an open-frame test chassis. Its feature
A Number That Looks Arbitrary A VMEbus backplane can have as many as 21 card slots. The limit can look
Rackmount enclosure with integrated backplane and card guides. On November 9, 2026, Fairbanks Morse Defense announced shipment of what it
VME is a standard way to put several electronic boards into one chassis so they can work together. It was
A recent announcement from New Wave Design highlights a system-level shift: its V6073 and V6074 3U VPX single-board computers combine
A rackmount system can meet its electrical and environmental requirements yet remain difficult to maintain. Cards may be hard to
A single-board computer (SBC) replacement can fit the same VME slot and use the same connector while changing the electrical,
The interconnect roadmap for VPX systems is advancing from discussion to implementation. ANSI/VITA 91.0-2024 is approved, and deployable systems using
A surface finish on a machined panel or chassis is not merely a color or corrosion choice. It can determine
Open architectures are moving from demonstrations toward production, flight testing, and deployment. That transition changes the engineering question. It is
A working rackmount chassis may be held together by a modest number of small screws. Those fasteners do more than
Vector 19" rackmount chassis with integrated backplane. For embedded hardware programs, supply risk is no longer confined to processors and
Vector 19-slot backplane with gold-plated connectors. Backplane designs are often reviewed in terms of slot count, pin count, signal topology,
Grounding and bonding in a rackmount system are not established by one wire or one fastener. They depend on a
The October 8 Military Embedded Systems vetronics roundtable put a sharp figure on a growing design challenge: power density per
First Article Inspection (FAI) is often treated as a documentation exercise performed at the end of a manufacturing launch. For
CompactPCI backplane selection is often reduced to slot count and board height. That approach misses the system-level decisions that determine
A connector datasheet defines the electrical and mechanical behavior of a mated interface under specified conditions. It generally assumes that
Legacy electronic systems rarely fail because a backplane is simply “old.” More often, the problem is that a backplane’s electrical